Hello Editsuite.com friends,

Due to tons of abuse, we now require that you request user access by sending us your Login, Name, Email Address, Phone Number, and Profession by submitting that info HERE.  I'll review your request and try to get back to you within the week.  You can't imagine how many folk want to trash forums with bogas advertising. 

Also, please help us gain enough Facebook "Likes" to have a custom Facebook URL!  

--Gary Lieberman

Seperating Devices (for Fast FFWD) on a 3/4k

2 replies [Last post]
Thu, 02/02/2006 - 13:38
Unger
User offline. Last seen 13 years 34 weeks ago. Offline
Joined: 2 Feb 2006

For Example...To run a Lum key on Channel 1(flare) and loop a bkd on channel 2, do you need to seperate the channels of the Lance in the 3/4k?

Unger

Top
Fri, 02/03/2006 - 03:43
#1
sahonen
User offline. Last seen 15 years 4 weeks ago. Offline
Joined: 18 Aug 2005
The Lance should only control whatever channels are delegated on the controller itself. If only the A channel is delegated and you send a trigger from the switcher, it will only affect channel A. What I'm not sure about is whether the Lance remembers which channels are delegated on a register-by-register basis. Try saving a register with only one channel enabled, manually delegate the other channel, then recall that register. If the delegation changes back to the first channel, then you should be good. If not, you may have to remember to manually punch up channel delegations during the show.
- Stephan Ahonen
Top
Thu, 02/02/2006 - 21:39
#2
Bill D
User offline. Last seen 10 years 34 weeks ago. Offline
Joined: 18 Aug 2005
[quote="Unger"]For Example...To run a Lum key on Channel 1(flare) and loop a bkd on channel 2, do you need to seperate the channels of the Lance in the 3/4k? Unger[/quote] Is this one particular effect or are you leaving this setup for the entire show. You could give them individual P-bus addresses on both Lance and 4K. This would probably make the most sense since one channel is a looping. Bill
Top