Anyone ever see this one?
- Login to post comments
Hello,
Was on a Zodiak yesterday...thanks you all for the help w/ info on the ZOdiak from my other post..
Here is my question. Was cutting on PGM/PST between 2 cameras...using the Cut button in the trans module. Cut to a camera...sources switched online...but when I looked at PGM/PST buses...they hadn't flip flopped. Then...what seemed like a few seconds later...they updated. It was like I had done an auto trans, and the buses didn't flip flop until the transition was complete. So...I thought either there was a glitch...or I hit the Auto trans by mistake. No one was yelling, and when I asked the director and another TD later on...neither one saw anything....So...I figured it was a glitch, or by chance no one noticed.
A few hrs later on another show, same setup and situation, it happened to me 2 other times.
After the show, thinking that the Zodiak control panel is connected to the chassis over a LAN..I thought it might be a network problem. Spoke to the EIC, and he confirmed that yes it was on a LAN..but it sounded like a dedicated LAN for the switcher and maybe the router...can't remember
My thought is that there was some sort of network issue that caused the control surface to be delayed in updating.
Anyone ever seen anything like this? Wasn't a big deal at all..Now I am just curious.
thank you
Curt
- Login to post comments
Dan, I'm also running the Mac M1 with Windows 10 ARM on Parallels, and was able to get it to...